RC Plane With Brushless Motor – ABS Plastic And PS Foam Hybrib 3D Printer Model
The file 'RC Plane With Brushless Motor – ABS Plastic And PS Foam Hybrib 3D Printer Model' is (stl,pdf) file type, size is 1.1MB.
The file 'RC Plane With Brushless Motor – ABS Plastic And PS Foam Hybrib 3D Printer Model' is (stl,pdf) file type, size is 1.1MB.
24 Nov - Updates to the full ABS version with a 1400mm wing span also available http://www.thingiverse.com/thing:33732
06 Nov - Slight tweaks to the rudder and tail fin... nothing that could not be done during the fitting process, just a minor refinement.
04 Nov - To avoid any confusion I have reduced the nunmber of files here and published a separate model for the full ABS version.
1 Nov - Updated nose cone / engine mount.
30 Oct - Instructions updated.
Based on a cub / trainer design aircraft, this thing is under construction to be a fully printable remote control aircraft.
More pics and the rest of the design to come as soon as I get a couple of parts from Hong Kong to complete the fuselage. The default pic is the assembled hull plus wings, pending reinforcement of the nose section with carbon tissue and then the heat shrink skin over the rest of the body.
| battery_and_controller_housing_-_V2.stl | 83.1KB | |
| battery_cover.stl | 111.1KB | |
| battery_door_mounts.stl | 56.4KB | |
| elevator_-_left_-_V3.stl | 112.7KB | |
| elevator_-_right_-_V3.stl | 125.4KB | |
| engine_mounting_block.stl | 26.4KB | |
| fuselage_sections_-_all.stl | 909.1KB | |
| Instructions_-_V2.pdf | 796.8KB | |
| landing_gear.stl | 87.4KB | |
| landing_gear_pad.stl | 3.0KB | |
| light_wt_wing_joiner_-_V8_-_5_degrees_-_LEFT.stl | 315.8KB | |
| light_wt_wing_joiner_-_V8_-_5_degrees_-_RIGHT.stl | 313.8KB | |
| light_wt_wing_joiner_-_x2_-_CTR_-_V2.stl | 242.6KB | |
| light_wt_wing_joiner_V8_-_LEFT_or_RIGHT_-_15_degrees.stl | 77.2KB | |
| mini_cub_spar_w_CF_braces_and_balsa_cut_outs_x8__-_V8.stl | 781.9KB | |
| rudder_-_V3.stl | 115.8KB | |
| tail_fin_-_V3.stl | 31.4KB | |
| tail_fin_bracket_-_V3.stl | 62.5KB | |
| tail_section_-_V3.stl | 180.6KB | |
| tail_wheel_bracket_-_V3.stl | 90.2KB | |
| tie_rod_ends.stl | 279.3KB | |
| wing_mount.stl | 191.3KB | |
| wing_tie_down_brackets.stl | 310.4KB | |
| wing_tip_-_V8_-_LEFT_and_RIGHT.stl | 342.4KB |
