RC Plane Wing Wall Mount Details and Print Settings

Detailed Components:

• Wing Holder:

  • The wall mount is sleek and simple allowing for a fast print and easy mounting. The V shape allows it to accommodate any RC plane type.

• Mounting Holes:

  • The mount has two 3mm screw holes with a counterbore allowing for a clean finish. For my wall mounting I used some cheap Amazon 3mm self-tapping round head screws. I used wall plugs to allow for a sturdy mounting to the wall.
• Inclined Support Design:
  • The inclined V shape in the mount allows for a comfy fit of nearly all RC Planes.

Print Settings:

To achieve the best results I recommend the following settings:

• Layer Height: 0.2 mm

  • A standard layer height that allows for a nice-looking finish.

• Infill: 20%

  • 20% is the recommended infill as it is strong enough, saves material, and allows for a light finish.

• Supports: Required for screw holes

  • for the screw holes you may need some support to prevent any warping, however good high-quality printers may be able to get away without needing any support.

• Print Speed: 200 to 250 mm/s

  • Thanks to the simple easy print design you can go pretty fast with the print speeds. However, it may be worth going with some moderation just so the screw holes don't get warped.

• Material: PLA

  • For my prints, I used PLA+ for the strength component however other strong sturdy materials will also surface. It may also be worth putting some foam in the holder to help pad the plane.
• Bed Adhesion: Use a heated bed (50-60°C for PLA, 70-80°C for PETG)
  • Ensure good bed adhesion to prevent warping and to maintain the dimensions of the printed parts accurately.

Assembly Tips:

• Mounting on Wall:
  • Use appropriate screws and wall anchors if needed to securely attach the mount to the wall.

Links:

• Instagram: Insta
• GitHub: GitHub
• BuyMeACoffee: Donate

NOTE: I used ChatGPT to generate the format and then edited it down to suit.