THIS IS NOT THE FINAL VERSION FEEL FREE TO REMIX IT
I used old RC car electronics to power it and rubber bands for suspension. The holes for sprockets should be drilled, these ones just match old the parts i had. You might have trouble orienting the front bottom part, but everything should fit on a 220x220 bed. Print the front roof on its walls.
Use supports and all parts should be fine on 20% infill, you might want to reinforce the hull walls.
the model is mostly accurate, about 22:1 scale (not sure, its been some time since i designed it), most of the tracks is guesswork, so dont expect to much detail from the model ;)
| cover.stl | 1.5MB | |
| front_bottom.stl | 301.1KB | |
| front_roof.stl | 2.4MB | |
| hand1.stl | 71.7KB | |
| hand2.stl | 43.3KB | |
| idler_wheel.stl | 2.1MB | |
| inner_support.stl | 291.3KB | |
| mid_roof.stl | 203.4KB | |
| optional_-water_plow-.stl | 78.6KB | |
| rear_bottom.stl | 423.6KB | |
| rear_plate.stl | 1.4MB | |
| rear_roof.stl | 50.1KB | |
| rim.stl | 1.3MB | |
| sprocket.stl | 2.0MB | |
| suspension_holder.stl | 261.6KB | |
| tire.stl | 2.0MB | |
| track_segment.stl | 271.4KB | |
| washer.stl | 56.3KB |
