this is a almost fully printable RC sailing boat .
the model is Laser dinghy 1:10 scale from real boat. total of 460 mm long
you will also need:
1 x Flysky FS-GR3E 3 Channel 2.4G Receiver & transmitter
1 meter aluminum tube diameter 10 mm.(the total length of the mast is 710 mm and the boom is 290 mm)
1 x sg9 servo motor
1 x 360 Degree Continuous Rotation RC Servo
2 x 10mm/0.39 inch Spring Clip
1 x push button 8x8 mm
1 x Rectangle Plastic 4 x 1.5V AAA Battery Holder
1 x WATERPROOF RIPSTOP NYLON FABRIC
1 X lead weight of about 400-500 g
Update 12/05/18:
added video of first water test
https://www.youtube.com/watch?v=byQVEPyXuh4
the bow is slightly diving in reach and it has some difficulty to jibe,
i added the short keel with 5 deg back to move the weight back a little.
also added a hydrofoil for keel and rudder and i cant wait to test it again..
https://www.thingiverse.com/thing:2907306
now i need to solve the balancing problem..
Update 17/05/18:
Added some pictures of the keel and rudder.
For the rudder pin I used M4x30 stainless steel bolt screwed to the rudder holder from bellow , I put a 6mm OD, 4mm ID stainless steel tube in the rudder for free movment.
For the keel I used a 400 grams lead fishing weight that I drilled in it to fix it with a M4 screw that goes to M4 nut that I put in the keel top.
| bottom_center.stl | 2.8MB | |
| bottom_center_L.stl | 1.5MB | |
| bottom_center_R.stl | 1.5MB | |
| bottom_quarter_L_2.stl | 2.2MB | |
| bottom_quarter_R.stl | 2.2MB | |
| bow.stl | 1.4MB | |
| keel_long.STL | 63.6KB | |
| keel_medium.STL | 76.5KB | |
| keel_short_5_deg.STL | 103.5KB | |
| keel_top_end.STL | 112.6KB | |
| lid.STL | 91.2KB | |
| mast_topp.STL | 196.1KB | |
| mast_to_boom2.STL | 54.8KB | |
| rudder.STL | 150.8KB | |
| rudder_holder.STL | 20.4KB | |
| stern.stl | 1.9MB | |
| top_center.stl | 2.7MB | |
| top_center_L.stl | 1.5MB | |
| top_center_R.stl | 1.4MB | |
| top_half.stl | 3.7MB |
