LOOK HERE FOR NEW VERSION - MUCH LESS SUPPORT NEEDED
This RC was inspired by '32 Ford hot rod trucks, without being specific to any particular model, it is built around a laser cut aluminium chassis with a 3D printed (SLS Nylon) shell.
The running gear is mostly sourced from the RC crawler world, aluminum hop-up axles, gearbox and suspension links.
Rear Axle
Front Axle
Rear Tyres
Motor and ESC
Transmission with Gears
Driveshaft
You can find the full build instructions here: www.instructables.com/id/Scratch-Build-an-RC-Car-With-CAD-and-Rapid-Prototy/
| floor_pan_bent.stl | 267.9KB | |
| floor_pan_profile_unfolded_2mm.dxf | 21.9KB | |
| frame_rails_6mm.dxf | 9.9KB | |
| Frame_Rail_-_Not_recommended_for_Printing.stl | 278.2KB | |
| front_suspension_mount_2mm.dxf | 3.2KB | |
| lower_suspension_bracket_2mm.dxf | 3.9KB | |
| radiator_cover_001.stl | 799.0KB | |
| radiator_profile_6mm.dxf | 6.1KB | |
| radiator_truss_bent.stl | 69.0KB | |
| radiator_truss_profile_2mm.dxf | 6.6KB | |
| shell_021.stl | 14.5MB | |
| transmission_tunnel_001.stl | 1.4MB |
