RC Hinge Cutting Jig 3D Printer Model
The file 'RC Hinge Cutting Jig 3D Printer Model' is (stl) file type, size is 106.6KB.
The file 'RC Hinge Cutting Jig 3D Printer Model' is (stl) file type, size is 106.6KB.
Based on hinge cutting guide that I found here on Thingiverse, but I though I would try to make one that clipped together in place of using self tapping screw etc.. Also
wanted one that was suitable for larger wings.
Standard guide block will accommodate thicknesses of 7mm to 35mm. At 35mm, the cutting guide may be difficult to keep aligned with the surface so I made a "support" guide block. This will support the jig against the piece at the guide blocks as well as at the cutting guide, but will increase the minimum thickness from 7mm to 11mm.
Also made a "Thin" guide block, will take minimum thickness down to zero, but also reduce maximum thickness down to 25mm.
| Hinge_Jig_Pivot_Arm.stl | 85.8KB | |
| Hinge_Jig_Slot_Arm.stl | 67.3KB | |
| Hinge_Jig_Std.stl | 120.0KB | |
| Hinge_Jig_Support.stl | 120.4KB | |
| Hinge_Jig_Thin.stl | 120.4KB |
