RC Crane V2 3D Printer Model
The file 'RC Crane V2 3D Printer Model' is (stl) file type, size is 3.2MB.
The file 'RC Crane V2 3D Printer Model' is (stl) file type, size is 3.2MB.
Enli10Me2 was a great start, but there were a few small things in my mind that would make it easier to build. I saw that his was based upon another build, so i took the good from that and combined.
First thing i did was enlarge the holes for the screws on the top parts where used. I found the 3m bolts i was using the heads kept stripping off, by doing this i was only putting pressure on where i needed the threads. I used the pulley, hook from ke5etc, also the pads and then modified the base beams to take a bigger screw.
Next I modified the Servo pully to fit on the servo gear, and the platform pully to accept a bearing on the top so it was free spinning.
I fixed the pins on the carriage as they were to big for the bearings.
I took the cab from the crane accessories and cut a slot in the side to run the RC cables.
Still have a few more things to do for cable management, and will post when i get them done.
This is still very much a work in progress, I will clean up the STL's and have some detailed pictures on the build and electronics when i get crane 2 completed
| 00.01_Base_Beam_v3_part_1.stl | 125.7KB | |
| 00.02_Base_Beam_V3_part_2.stl | 153.9KB | |
| 00.03_Tower_Frame_Base.stl | 1.6MB | |
| 00.04__Tower_Frame_X8.stl | 658.2KB | |
| 00.05_Tower_Frame_Motor_Platform.stl | 757.4KB | |
| 00.06_Tower_Frame_Top.stl | 658.2KB | |
| 00.07_Cab.stl | 31.9KB | |
| 00.07_Cab_Back.stl | 52.2KB | |
| 01.01_BLK_Cab_Window.stl | 78.8KB | |
| 01.02_BLK_Cab_Windshield.stl | 8.1KB | |
| 01.03_BLK_Carriage.stl | 366.9KB | |
| 01.04_BLK_Motor_Enclosure.stl | 658.8KB | |
| 01.05_BLK_Motor_Assembly_base_plate.stl | 643.8KB | |
| 01.06_BLK_Bottom_Cover.stl | 320.6KB | |
| 01.07_BLK_Base_Gear.stl | 455.6KB | |
| 01.08_BLK_Motor_Shaft_Gear.stl | 56.5KB | |
| 01.09_BLK_Motor_Shaft_Base.stl | 643.8KB | |
| 01.10_BLK_Carriage_Pulley_X_2.stl | 879.8KB | |
| 01.11.BLK_Platform_Pulley.stl | 70.6KB | |
| 01.12_BLK_Truss_Arm_Pulley_X_2.stl | 867.9KB | |
| 01.13_BLK_Servo_Pulley.stl | 163.3KB | |
| 01.14_BLK_Light_Post.stl | 15.7KB | |
| 02.01_GRY_Cab_Ladder.stl | 935.5KB |
