RC Boat 3DBenchy 3D Printer Model
The file 'RC Boat 3DBenchy 3D Printer Model' is (stl) file type, size is 1.5MB.
The file 'RC Boat 3DBenchy 3D Printer Model' is (stl) file type, size is 1.5MB.
So i decided to make an RC-Benchy boat. Its printed with 25% infill ABS
I printed it on my regular prusa printer and my D-bot. I glued the parts with ABS-slurry (A cup of Acetone and some abs filament for glue) I also used the slurry and applied it to the body to make it waterproof, 2-3 layers.
There is one thing i would have done differently then i assembled the motor DO NOT use a glue gun, buy some epoxy-glue instead. I have some small leakage from the motor, so i removed all the glue and used ABS-juice to glue those parts also, but epoxy would have been a better option. I also integrated the support for the servo in the hull.
Update:There was no valid volume for the bodyparts that i had split, but i have re-uploaded them now so they are fine, but of course you can split the fullsizebody to as many parts you like.
The parts I have been using is these:
Rc-controller - https://goo.gl/qMHYCG
ESC - https://goo.gl/7bu7ou
Servo - https://goo.gl/igrLKy
Steel shaft for servo - https://goo.gl/bGjfYv
Water proof plastic organ sleeve - https://goo.gl/X2DQ3i
Lipo battery - https://goo.gl/Sz3hNR
Lipo battery if not shipping to your country - https://goo.gl/1NdsGF
Battery charger - https://goo.gl/ARW9yc
Jet motor - https://goo.gl/6TM7CJ
Epoxy-glue - https://goo.gl/wux3mr
XT-cable converter https://goo.gl/KfVtNN
​3 mm inner diameter sillicone tube - https://goo.gl/1QEdMs
Tools:
3D-printer - https://goo.gl/VTXWFa
Solderiron - https://goo.gl/SE2Kiz
Solder helpinghand - https://goo.gl/nwfH0x
Cutting Plier - https://goo.gl/nwfH0x
Build instructions here:
Instructables step-by-step guide:
http://www.instructables.com/id/RC-Boat-3DBenchy/
you can see it in action here:
If you like what I do consider leaving a small tip to support me for more designs, thank you :)
| Benchybody_fullsize.stl | 1.1MB | |
| Benchybody_split_back1.stl | 258.7KB | |
| Benchybody_split_back2.stl | 353.3KB | |
| Benchybody_split_front1.stl | 207.2KB | |
| Benchybody_split_front2.stl | 198.9KB | |
| Benchybody_split_mid1.stl | 169.9KB | |
| Benchybody_split_mid2.stl | 188.7KB | |
| Cabin.stl | 445.7KB | |
| Eyes_for_LEDlight.stl | 506.5KB | |
| Pipe.stl | 296.9KB | |
| steeingwheel.stl | 90.7KB |
