Rc Boat 3D Printer Model
The file 'Rc Boat 3D Printer Model' is (stl) file type, size is 3.6MB.
The file 'Rc Boat 3D Printer Model' is (stl) file type, size is 3.6MB.
this is a simple 3d printed rc boat that is powered by a 2205 2300kv outrunner motor. other similar motors could be used though.
the hull can be printed in one piece on a printer having a vertical work space of around 300 mm.
i used the following components:
update june 17th:
the center of gravity of the boat is located too far towards the bow. in order to correct this i modified the hull (v2) such that the lipo can be placed towards the stern, right over the drive shaft. a new cover on which the lipo rests as well as a side guide for the lipo are also part of this modification.
update october 9th:
the boat was never very stable so i redesigned the hull (see files "Boat_v2..."). i also made it a bit larger since it was too heavy for its size. i uploaded a full hull and one that i split in two pieces. the two pieces can simply be aligned and glued together.
| Arm.stl | 236.7KB | |
| Boat_v2_Arm.stl | 199.4KB | |
| Boat_v2_CouplerAxle.stl | 140.8KB | |
| Boat_v2_CouplerMotor.stl | 405.8KB | |
| Boat_v2_CoverLeft.stl | 179.5KB | |
| Boat_v2_CoverRight.stl | 145.7KB | |
| Boat_v2_Hull_All.stl | 1.1MB | |
| Boat_v2_Hull_Bow.stl | 934.0KB | |
| Boat_v2_Hull_Stern.stl | 649.2KB | |
| Boat_v2_MotorHolder.stl | 108.2KB | |
| Boat_v2_rudder.stl | 170.0KB | |
| Boat_v2_ServoHolder.stl | 7.3KB | |
| Boat_v2_SupportLeftNRight.stl | 26.8KB | |
| CouplerAxle.stl | 71.1KB | |
| CouplerMetalBuy.stl | 54.2KB | |
| CouplerMotor.stl | 198.1KB | |
| CoverLeft.stl | 182.9KB | |
| CoverRight.stl | 181.5KB | |
| Hull_v2.stl | 3.6MB | |
| LiPoSideGuide.stl | 11.8KB | |
| LiPoSupport.stl | 24.0KB | |
| MotorHolder.stl | 227.2KB | |
| Propeller.stl | 955.4KB | |
| Rudder.stl | 472.5KB | |
| ServoHolder.stl | 7.0KB | |
| SupportLeft.stl | 38.4KB | |
| SupportRight.stl | 38.4KB |
