[RaspRail] Fan Duct 3D Printer Model
The file '[RaspRail] Fan Duct 3D Printer Model' is (CATPart,stl) file type, size is 273.9KB.
The file '[RaspRail] Fan Duct 3D Printer Model' is (CATPart,stl) file type, size is 273.9KB.
This duct is used to have the inlet for the fan point in a direction. It can be used to block some of the dust falling from above the raspberry pi. The air inlet should be on the bottom side.
This is an add on for the RaspRail case (http://www.thingiverse.com/thing:389705).
| Raspberry_Case3_Fan_Duct_V2.CATPart | 629.8KB | |
| Raspberry_Case3_Fan_Duct_V2.stl | 154.1KB |
