Raspberry Pi Zero and Pi Zero 2 Case

• Compatible with old & newer Pi Zero, Pi Zero 2 & Pi Zero W (includes a camera ribbon slot)
• Snap fit design - no screws required.
• Heat sink hole for the 2W variation.
• "Coin slot" provided to prise lid open.
• Easy to insert the Pi into the case
• Screw holes case for screwing through back of case for mounting plus other mountings
• Vented lids to let Pi breath
• Small IO & larger IDE style connector slot version
• Extra deep version is for use with IO port connector soldered to board, thus needing room for pins to stick out under the board.
• 2020 extrusion adapter, https://www.thingiverse.com/thing:5180242

If using the internal screw holes, ensure the screw head is not going to short against the Pi, I'd recommend some electrical insulation tape over the top of the screw heads before mounting the Pi for peace of mind.

Note: You may need tweezers or fine nose pliers to take out the SD card once inserted, design compromise to keep the design simple and neat.

The Pi is very snug in its case to keep the footprint to smallest I could.
Feed camera ribbon through slot and insert into Pi, then lower Pi into place.

Download all files as zip to see full filenames and for a full kit of parts!

The OctoPi "sticker" is intended to be printed and then gluued to the front of one of vented cases, or whatever else you want...

6mm tall heatsinks will be flush with the top of the case, however taller heat sinks can be used, they will just stick out the top a little.

Version History
03 Dec 2015 - Added V1 vented lid.
03 Dec 2015 - Added V2 shell with smaller PCB pegs,
04 Dec 2015 - Added V2 vented lid with better pegs
04 Dec 2015 - Added V2 non vented lid with better pegs
05 Dec 2015 - Updated shell to V3 to correct one peg that was undersize
29 Dec 2015 - Added V3 with internal mounting holes
08 May 2016 - Added vented lid with small & large IO slot
30 Dec 2016 - Added V4 with camera slot and improvements to make it easier to insert the Pi into the case also added mounting holes in a variant of V4
01 July 2017 - Noticed a problem on basic vented lid rounding of vents, corrected with new version
03 July 2017 - Uploaded all files again with new smarter names
26 Dec 2017 - Added RPi Logo Version - please check for TradeMark restrictions https://www.raspberrypi.org/trademark-rules/
Added extra deep version
28 Dec 2017 - Added OctoPi stick on
23 Nov 2021 - Updated description for Pi Zero 2 compatibility
26 Dec 2021 - Updated with Pi Zero 2W Heatsink version (note the chip position and size is different to previous zeros suitable for up to a max of 15mm square heatsink)
29 Dec 2021 - Added RPi_Zero_2W_WithHeatsink v7.stl that has slightly larger heatsink hole
31 Dec 2021 - Added 2020 reference to adapter and updated description