Raspberry Pi Zero LAN/USB Hat Case With Camera Slot And Screw Mounts And Fan Holder 3D Printer Model Free Download

Description Files (3)

Summary

Print with Tree Supports to build plate only ideally.

Two versions, 25mm and 30mm case fans including a small slot for the fan wire to go back into the case.
(I have withdrawn the 25mm version until I can test it.)

I have not tested the 25mm version, only the 30mm version.

I used M3 Nuts and M3*16mm Hex head bolts to hold the 30mm fan in place, these fit perfectly if you also use the fan guard linked below, otherwise, spacing washers will also work, or of course, shorter bolts..

No, it's not noisy, I used a 5v fan, from Pi-hut, it's silent. Stops ALL throttling. I didn't put an aluminuim type heatsink on the pi-Zero 2w, but I did stick on a 2mm flat copper plate type heatsink.

I have included the lid in the STL list for convenience. I have also included a USB LOOP COVER file, this prints a little cover to go over the Micro USB loop on the outside. Makes things look a little neater.

The LAN/USB Hat is a 'Waveshare Eth/USB Hat' from Pi-Hut.

The Fan covers can be found here :- https://www.thingiverse.com/thing:2523236

The original design for this case :- https://www.thingiverse.com/thing:5100304 - This is where you download the lid from. The original lid should still fit.

The Waveshare hat :- https://thepihut.com/products/ethernet-and-usb-hub-hat-for-raspberry-pi

The Pi-Zero 2w :- https://thepihut.com/products/raspberry-pi-zero-2?variant=43855634497731

FAN (There are many options, this is the cheap, software controlled are probably best) :- https://thepihut.com/products/software-controllable-5v-30mm-fan-for-raspberry-pi

PI-ZERO_2W_HOLDER_With_Camera_slot_-_Wall_Mounting_with_30mm_fan.stl	631.1KB
PI_HAT_USB_LOOP_COVER.stl	1.4KB
Pi_Zero_Lan_Hat_cover.stl	37.9KB

Raspberry Pi Zero LAN/USB Hat Case With Camera Slot And Screw Mounts And Fan Holder 3D Printer Model

Summary

Tags

You might also like