A simple display case for the Raspberry Pi 2 & 3 Model B. I used a 3.5inch touchscreen LCD, which is purchased from ebay. Link and guide is listed below.
The micro SD card is accessible from outside. A special feature is, that it is held in place, even when the spring loaded mechanism of the sd slot fails (which happened here).
The raspi is entirely passive cooled. I have not used a heat sink or a fan.
Do not print assembly.stl. I have three different top parts. I only used and printed that width the display. I used some weak glue to bind the parts together.
If this is not enough for you, feel free to send me a message :)
User-specified models:
raspiBplusCase_top_differentCutout.stl
raspiBplusCase_top_extraTall.stl
(I used the raspbian image)
| assembly.stl | 311.7KB | |
| assembly2.stl | 293.7KB | |
| raspiBplusCase_base.stl | 252.6KB | |
| raspiBplusCase_base_w_sdSlot.stl | 221.1KB | |
| raspiBplusCase_raw.zip | 124.3KB | |
| raspiBplusCase_top.stl | 39.5KB | |
| raspiBplusCase_top_differentCutout.stl | 39.5KB | |
| raspiBplusCase_top_differentCutout_extraTall.stl | 48.9KB | |
| raspiBplusCase_top_extraTall.stl | 48.9KB | |
| raspiBplusCase_top_wo_display.stl | 30.0KB | |
| raspiBplusCase_top_wo_display_logo.stl | 57.5KB | |
| spacer.stl | 14.3KB |
