Made several improvements to original design which had a few problems for me:
• Correctly located mounts from 55mm to 58mm spacing
• Increased ventilation by adding holes to sides and bottom
• Increased thickness of top so GPIO pins don't extend out of case
• Correctly centered fan opening
• Correctly sized and spaced GPIO header cutout in top
• Resized mount holes to fit screws that come with Pimoroni base.
Tips:
• Base goes on bottom of mount and Pi on top, no need for standoffs. Use long screws.
• Assemble NVME ribbon cable between base and Pi then gently insert into mount and screw down
• Trim a small piece of the foam that is on the header of the Waveshare to use as protection/plug for Pi header when in the case.
• Use rubber feet that come with Pimoroni on base.
• I didn't use button from original file (will use a pin if needed) but it will still fit if you want to grab it.
| Bottom_Cover_V2.stl | 1.8MB | |
| Case_Body_V2.stl | 730.0KB | |
| Top_Cover_V2.stl | 213.2KB |
