UPDATE2020: added Ramps-Case-Big-Display.rsdoc - Designspark Mechanical File

UPDATE: added files for the case you dont want to use a display or a complete extern display. the two new files also made to take a 80x80mm Fan. :)

New Clips for mendelmax and tmax Frame are up. (latest Clips only work with latest case files)

optimized part "lid-fan-Display.stl", new uploaded. now with a Clip to hold the Display cable in place and a fan-guard to protect your fingers... ;)

Case_V3_backhole.stl:
case with cable-hole on the airguide side and closed at the bottom. (one of the bottom holes should only be closed by 2-3 layers and could easy cut open if needed)

This is still "Under Construction" Remix of the Case i did for Rumba with
Full Graphic Smart Controller -> http://www.thingiverse.com/thing:516447

The Knobs and the Airguides of the original do fit into this Remix:
http://www.thingiverse.com/thing:523054
http://www.thingiverse.com/thing:523003

check the "Remix" section for more...

The display-Frame is also the same part as in the original. Case and Lid/Fan/Display Holder part are changed. i also integrated a hinge to work with open case...

the Clips are made to Clip the box on a mendelmax Frame with 70mm distance. you can also fix the case with M3x10-12mm screws directly to the extrusions. the hole distance is 50mm. that one hole wich is placed under the arduino mega pcb Needs to be a m3x6-8mm one without a spacer. if the head of this screw is higher than 3mm it touches the pcb!!! be shure to have enough clearance at that Point!

with a 60x60x25mm fan you need to lift the mendelmax around 30mm up to get clearance for the fan. if you take a 60x60x10mm one you need 20mm between the extrusions and your table.

this Thing is not printed by myself Jet and i guess i dont need one any time... so please if you print one upload a few pics and give me Feedback how the parts fit in the comments.

the hinge needs support the way ist done at the moment. hopefully i get an idea of how to get rid of this...