Radxa Penta Sata Case 3D Printer Model
The file 'Radxa Penta Sata Case 3D Printer Model' is (stl) file type, size is 2.1MB.
The file 'Radxa Penta Sata Case 3D Printer Model' is (stl) file type, size is 2.1MB.
Simple case for Radxa penta sata hat.
Works with RASPBERRY PI5 ONLY
Does not work with the TOP HAT BOARD
Only requirements are:
4 x m4 screws for case
1 x 40mm fan
4 x screws (m4?) for fan
It's a tight fit, so follow assembly steps:
Fit penta hat to raspberry pi according to manufacturer instructions.
Then, remove 4x standoffs from underside of Pi5. Keep board on top of Pi though (held on by GPIO header.
Fit Pi and hat into case.
Fit standoffs back onto Pi on underside of case. They will attach the Pi to the case and act as feet.
Fit 40mm fan to 12v molex plug.
Add drives to penta hat, all connected together with supplied cage.
Fit fan to lid.
Fit lid onto case.
M4 screws will self-tap into the lid securely.
Only use this case vertically (Pi at the bottom) since there is nothing securing the drives in place.
| penta_case1-Base.stl | 4.1MB | |
| penta_case1-lidPad008.stl | 1.6MB |
