Radiomaster Zorro Momentary Switch Conversion 3D Printer Model
The file 'Radiomaster Zorro Momentary Switch Conversion 3D Printer Model' is (STL) file type, size is 679.7KB.
The file 'Radiomaster Zorro Momentary Switch Conversion 3D Printer Model' is (STL) file type, size is 679.7KB.
Hi everyone,
I've always wanted more switches on my Radiomaster Zorro. Since I never use the momentary push buttons A and D, I decided to convert them into standard switches.
The assembly is straightforward—just make sure to install the switch so that when you pull it up, it presses down on the button. To attach the switch to the converter, use a small piece of PLA filament.
Before applying any glue, run a couple of tests and check the Zorro's screen to ensure the commands work properly when you move the switch. When you’re ready to glue, use just a tiny bit on the very edge of the outer perimeter (any more and you risk gluing the button itself—don’t ask how I know this).
It’s easier to glue the base without the switch so you can align it with the button more precisely. Once the base is set, install the switch with the filament.
Proceed at your own risk; I have decent manual skills, and my switches work perfectly.
| switch.STL | 1.8MB | |
| switch_converter.STL | 125.5KB |
