Racing Quad X-Frame (Multi-size) 3D Printer Model
The file 'Racing Quad X-Frame (Multi-size) 3D Printer Model' is (stl) file type, size is 17.3MB.
The file 'Racing Quad X-Frame (Multi-size) 3D Printer Model' is (stl) file type, size is 17.3MB.
I have simple x-frame designs for multiple prop sizes. The frame thickness varies, but is designed for strength in normal flight movement. Screw holes are not designed into the frame due to the nature of printing and weak spot generation. Screw hole starter locations are marked and will need to be drilled with 2mm and 3mm drill bits.
The canopy is specifically designed for the RunCam Micro Swift 2 (or clones), but any camera with a 19mm width will fit. The canopies are all the same and will fit their corresponding frames, but will also fit any frame that has a 28.5mm x 28.5mm standoff hole pattern.
The LED bracket is designed to be used with the HGLRC W2812B LED/Beeper combo board. No glue is needed and the LED/beeper can be mounted into the bracket after wiring is soldered to the main flight board.
The frame and canopy are designed to be used with aluminum standoffs. Printed standoffs would have a higher likelihood of failure during flight, but could be engineered to work effectively.
I recommend printing this frame with 10(ish) walls and 100% infill. This will provide added stiffness and strength while providing a good product for drilling.
The pictured, fully built, quad is capable of hitting 100mph and has very high acceleration with the 1406 motors installed. It uses a 20mm x 20mm HGLRC flight stack with 25mm standoffs. The frame is more than capable of handling that all movement when printed in PLA. However, it will likely snap in a relatively higher speed crash. Other materials may provide more support in this area.
85mm Frame: 2in props
87mm Frames: 2in props
100mm Frames: 2.5in props
112mm Frames: 3in props
184mm Frames: 5in props
| 100mm_Canopy.stl | 1.2MB | |
| 100mm_Frame.stl | 3.6MB | |
| 100mm_S-Frame.stl | 4.3MB | |
| 112mm_Canopy.stl | 1.2MB | |
| 112mm_Frame.stl | 3.6MB | |
| 112mm_S-Frame.stl | 4.4MB | |
| 184mm_Canopy.stl | 1.2MB | |
| 184mm_Frame.stl | 3.8MB | |
| 184mm_Frame_v2.stl | 6.1MB | |
| 184mm_S-Frame.stl | 4.4MB | |
| 85mm_Canopy.stl | 1.1MB | |
| 85mm_Frame.stl | 3.6MB | |
| 87mm_Canopy.stl | 1.2MB | |
| 87mm_Frame.stl | 3.6MB | |
| 87mm_S-Frame.stl | 4.2MB | |
| Diamond_Frame_LED_Bracket.stl | 132.6KB | |
| LED_Bracket_Cover.stl | 61.6KB |
