Quick Release E3D Fan Duct For Dibond Mendel90 3D Printer Model
The file 'Quick Release E3D Fan Duct For Dibond Mendel90 3D Printer Model' is (stl,123dx) file type, size is 3.6MB.
The file 'Quick Release E3D Fan Duct For Dibond Mendel90 3D Printer Model' is (stl,123dx) file type, size is 3.6MB.
A fan duct for cooling prints which can be used instead of the standard fan duct when upgrading from the J Head to an E3D hot end (in my case a v6) on a dibond NopHead Mendel90. It uses the same 60mm fan as supplied by NopHead.
This is the second version of this duct and incorporates a quick release mechanism as well as more flexible height adjustment (a common request I got on the original one here: http://www.thingiverse.com/thing:491316 )
I have marked it as a work in progress because even though it works great I have had issues with the release lever snapping off (ABS can be very brittle). I need to do a test print in Bridge (Nylon) to see if this solves the problem. You can repair the lever by using acetone as a glue but I have found even with the lever snapped off it still works great as it stays in place with friction (depending on your tolerances you might want add a bit of tape over the top to make it push in tighter).
NOTE: This will not fit a Sturdy Mendel90 it only fits a Dibond Mendel90. If anyone modifies it to fit please let me know and I'll include a link :)
| FanDuct-Bracket.stl | 2.3MB | |
| FanDuct-Duct.stl | 26.3MB | |
| Fan_Duct.123dx | 516.1KB |
