I have a well-used and admittedly cheap camera tripod that I use for all kinds of photography, BUT I HAVE ONLY ONE MOUNTING PLATE.- an easy problem to solve through the magic of 3D printing.

Uses a 1/4- 20 screw for the camera attachment and Includes a nut trap for an adjustable/removable indexing pin - uses a 6-32 nut and slotted set screw.

Fits the tripod snugly. Ambico / Velbon / Amazon house brand and possibly other inexpensive tripods. 45mm / 1-3/4 inches square dovetail design.

Gonna need a couple more...
UPDATE: I printed a couple more. I found that the base plate is too large to fit on the PINHE4D http://www.thingiverse.com/thing:132517 35mm 3Dprinted pinhole camera without a fiddly spacer. So, I modified the design to taper to a smaller base for tight applications. Find the alternate design in the downloads section.

If there's any interest, I will make a parameterized version for similar mounts.

ATTENTION
This work is licensed under the Creative Commons - Attribution - Non-Commercial license. This license applies only to the files and documents available for download from the Thing Files section of this Thing.
All other related content (photographs, videos, and verbiage such as contained in "Description" or "Instructions" ) are excluded from this license. with all rights reserved, unless specifically available for download This notice constitutes a clarification, not a change, to licensing for this design.