UPDATE August 6 2019 Version 2 is 2mm thinner and includes an updated bottom half with cutouts for female headers.
Fit Enclosure
This enclosure is designed to secure the PyGamer PCB without any hardware screws. The PCB rests on bottom half with built-in standoffs. The top half features cutouts for the thumb stick, buttons and display. The two halves snap fit together and clamp shut. Features on the edges of the snap allow the case to firmly stay shut but also allow it to re-open.
Assembly photos in Learn Guide
https://learn.adafruit.com/pygamer-snapfit-case/
Adafruit PyGame
https://adafru.it/4242
Mini oval speaker 8ohm 1w
https://adafru.it/4227
350mah 3.7v lipo battery
https://adafru.it/4237
Fully reversible microUSB cable
https://adafru.it/4111
Button caps
https://adafru.it/4228
| bezel.stl | 2.8KB | |
| braille-alphabet.zip | 245.4KB | |
| button-cap.stl | 21.8KB | |
| button.stl | 168.8KB | |
| pyg-bot-headers.stl | 78.6KB | |
| pyg-bot-v2.stl | 74.3KB | |
| pyg-bot-wing.stl | 89.8KB | |
| pyg-top-v2.stl | 58.7KB | |
| PyGamer_Snapfit_Case.f3d | 4.9MB | |
| PyGamer_Snapfit_Case.step | 7.0MB |
