Snap Fit Enclosure
This enclosure is designed to secure the PyBadge PCB without any hardware screws. The PCB rests on bottom half with built-in standoffs. The top half features cutouts for the buttons and display. The two halves snap fit together and clamp shut. Features on the edges of the snap allow the case to firmly stay shut but also allow it to re-open. Bottom half features a cutout for FeatherWings. Extra thick loops for clipping lanyards.
PyBadge
https://www.adafruit.com/product/4200
PyBadge LC
https://www.adafruit.com/product/3939
Mini oval speaker 8ohm 1w
https://adafru.it/4227
350mah 3.7v lipo battery
https://adafru.it/4237
Fully reversible microUSB cable
https://adafru.it/4111
Adafruit_AirLift_FeatherWing.f3d | 1.5MB | |
Adafruit_AirLift_FeatherWing.step | 2.2MB | |
Adafruit_AirLift_FeatherWing.stl | 1.6MB | |
PyBadge.f3d | 3.0MB | |
PyBadge.step | 5.1MB | |
PyBadge.stl | 3.7MB | |
pybadge_featherwing_snapfit_case.f3d | 6.0MB | |
pybadge_featherwing_snapfit_case.step | 8.7MB | |
snapfit-bezel.stl | 3.6KB | |
snapfit-bottom-wing.stl | 116.5KB | |
snapfit-reset.stl | 45.2KB | |
snapfit-topcover.stl | 43.4KB |