PVC Bracket Spool Holder 3D Printer Model
The file 'PVC Bracket Spool Holder 3D Printer Model' is (STL) file type, size is 660.4KB.
The file 'PVC Bracket Spool Holder 3D Printer Model' is (STL) file type, size is 660.4KB.
Buying less than $5 worth of parts from the hardware and printing 2 brackets you can have an above filament spool holder that can carry up to 5 spools. It is very strong, and eliminates filament tangle (and breakage). Beauty of this design, it's easy to take apart for spool replacement, and if you decide you need another 5 spools, just replace the elbow with a Tee and go up another level. This does require you to drill 2 sets of holes into the top metal frame, 2 inches apart, using a .125" drill-bit.
The bracket has a chamfer and a lead-in draft so it's easy to insert, but gets nice and snug tight when it bottoms out.
Requires you to buy:
Four 6-32 x 2" screws
Four 6-32 locking nuts
a length of 3/4" PVC pipe (enough for at least 32")
2 PVC elbows
On a monoprice / flashforge creator X printer, I made the horizontal PVC pipe 15.5" long, and the 2 uprights 8" long each. Hole were drilled 1" offset from the inner cutout.
| pvc_spooL-holder.STL | 1.7MB |
