A puzzle plane held together by magnets. A great creative project for adults and children alike!
SELL PRINTS OF MY DESIGNS! License available here:
https://cults3d.com/en/3d-model/various/commercial-license-for-all-my-models
DISCLAIMER
Due to their small size and the potential risk of detachment, magnets may pose a hazard to young children. As a result, this particular design is not recommended for children between the ages of 0 and 3. https://www.org/English/safety-prevention/at-home/Pages/Dangers-of-Magnetic-Toys-and-Fake-Piercings.aspx
DESCRIPTION
Should you need higher quality STLs or the source STEP file so that you can easily make changes to the model, consider purchasing those here https://www.etsy.com/listing/679397939/puzzle-plane-for-3d-printing-stl
In addition to the printed parts, you will require the magnets (3mm tall, 6mm diameter). There are 63 magnet sockets in total but I used probably 55 magnets.
Dimensions (L x W x H): 217mn x 255mm x 116mm
Cut up for minimal support requirement. To secure the magnets in the pockets, I used Super Glue which proved to be effective. However, caution must be exercised during this process as any spillage of the glue may cause the plastic components to adhere together.
| Below_Cockpit.stl | 2.5MB | |
| Cockpit.stl | 1.1MB | |
| Engine_A_x2.stl | 3.5MB | |
| Engine_B_x2.stl | 2.4MB | |
| Fuselage_Top_Back_A.stl | 1.3MB | |
| Fuselage_Top_Back_B.stl | 1.7MB | |
| Fuselage_Top_Front.stl | 1.1MB | |
| Fuslage_Bottom.stl | 3.5MB | |
| Horizontal_St_L.stl | 2.5MB | |
| Horizontal_St_R.stl | 2.4MB | |
| Landing_Gear_L.stl | 1.6MB | |
| Landing_Gear_R.stl | 1.8MB | |
| Tyre_Front.stl | 2.9MB | |
| Tyre_Rear_Half_x4.stl | 1.7MB | |
| Vertical_Stabiliser.stl | 2.3MB | |
| Wheel_Front_Half_x2.stl | 677.8KB | |
| Windshield.stl | 977.1KB | |
| Wing_L.stl | 2.4MB | |
| Wing_R.stl | 2.4MB |
![Slinky [Toy Story] 3D Printer Model](https://res.3axis.co/ffd959c8-2302-41a1-8513-dd7a610a34b2/images/25cc1f87-4dd0-4aad-85c3-6b7012958ed5_thumb.jpg)
