This is a rough prototype to test the locking mechanism. Needs a few more embellishments but I doubt I will get around to that.
Puzzle box consisting of four sliding latches which must all be placed in the correct position in order to open the box.
Prints in place (tolerances are a little tight, the way I like them - dial in your first layer!)
| box.scad | 4.6KB | |
| box.stl | 33.1KB | |
| box75.stl | 49.1KB | |
| box75s.stl | 50.1KB | |
| lid.stl | 25.7KB | |
| lid75.stl | 28.8KB |
