This is a ball return I design for my basic Callaway putting mat I picked up from target.
It works suprisingly well on a hard flat surface and returns the ball just to the very back of the mat but no further.
Minimal post processing was required except cutting a half cylinder out of the bottom of the foam behind the hole to allow the ball to roll back through.
| Cup_angle.stl | 59.5KB | |
| Put_Return.stl | 458.3KB | |
| Put_Return_L1.stl | 26.2KB | |
| Put_Return_L2.stl | 91.3KB | |
| Put_Return_L3.stl | 332.1KB | |
| Put_Return_R1.stl | 25.8KB | |
| Put_Return_R2.stl | 90.4KB | |
| Put_Return_R3.stl | 318.1KB |
