The file 'Push Bloc 3D Printer Model' is (stl) file type, size is 250.2KB.
This is my take on a push stick for a table saw. It is designed after a commercial one I found online that I liked which offsets your hand for better safely and visibility.
Based on feedback, v2 was just uploaded. It's a little smaller (handle is the same size) and made to print upright with supports.
Warning: I would not print this in PLA as it might not be rigid enough. Mine was printed in ABS. Nylon would likely be best, but mine appears to be quite strong. It was also printed with 33% infill and 4 perimeter shells.
Push_Bloc.stl | 292.8KB | |
Push_Bloc.v2.stl | 273.3KB |