This pull relief is made for 6 mm cables (antenna cable in my case).
Print it with 0.1 mm layer height and everything should work fine.
bruncedric relesed thing:5262888, which is very similar. His "cable screw conector" is for a greater variety of cables. Check it out!
I needed it a lot smaller and as bruncedric didn´t allow derivates, I had to draw everything from scratch. I will use two of mine to build an 1800 Mhz-LTE-Antenna.
Use Freecad to modify/remix it.
| hutmutter.FCStd | 233.9KB | |
| hutmutter.stl | 77.5KB | |
| keil.FCStd | 31.7KB | |
| keil.stl | 33.6KB | |
| mutter.FCStd | 188.7KB | |
| mutter.stl | 49.4KB | |
| schraube.FCStd | 838.7KB | |
| schraube.stl | 751.9KB |
