Laser cut stand for PSVR headset and controllers.
Designed for 3mm acrylic with captive nuts using M3X16 bolts, a bit fiddly to put together but fairly solid once built. It probably has too many fixings, but you could always design some out.
Headset hangs on the front, with space to hang two move controllers and an ordinary playstation controller on the rear. Headset cable can be hung off the back over the controllers and charger cables can be fed in the back of the stand for the controllers.
I designed this for 3mm acrylic as I had some spare lying around, should be fine in 3mm ply but if cutting in a thicker material the designs will need amending.
It was cut on my cheap Chinese laser cutter so designed to fit a limited cutting area - it could be redesigned to be less pieces but this would need a bigger cutting area.
| psvr_stand.dxf | 331.5KB |
