PS3 Eye Cam Mount For Foldback / Binder Clips 3D Printer Model
The file 'PS3 Eye Cam Mount For Foldback / Binder Clips 3D Printer Model' is (stl) file type, size is 15.9KB.
The file 'PS3 Eye Cam Mount For Foldback / Binder Clips 3D Printer Model' is (stl) file type, size is 15.9KB.
Hello, I've designed this camera mount for the Playstation 3 Eye camera to clamp it with two 25 mm wide foldback clips, using the clip-on design from sb43201.
The camera just slides in and fits snug due the rubber on the cam's bottom.
You have to remove the upper lever from the clip to slide it in the holder, then reassemble through the gap as you can see in the picture. It can be a bit tricky though, a small screwdriver may be helpful directing it back in!
Print it upright as you can see in the second picture and use support (only touching build plate) because theres a small gap between. It'll be easily to remove. A 0.2 mm layer height should be best.
EDIT: For some printers it will be too close to the X carriage when the bed hits the endstop. I'll upload a more extended mount asap.
| PS3Cam.stl | 46.5KB |
