The file 'Prusa I3/Wilson Y-Carriage For Use With MRice’s Single Piece Y-ends (with Solidworks Source) 3D Printer Model' is (pdf,SLDPRT,STL) file type, size is 2.9MB.
In the spirit of mrice's singe piece Y-ends the design intent for this Y-Carriage was to reduce part count and remove any set-up errors / fiddling you get with the "separate bearing holders and belt holder" designs:
give a precise mounting for four linear bearings, keeping them parallel.
integrate a belt lands / clamps in the right place for mrices single piece y ends http://www.thingiverse.com/thing:132739.
Integrate a cable land / securing point for the heat bed cables.
Various edges are chamfered to avoid any sharp edges / abrasion.
2015-04-06 Added the simple plate to mount a standard 200mm PCB heat bed to the carriage. I haven't made/tried this yet.
| Bed_Mount_sheet_-_Sheet5.pdf | 11.7KB | |
| Belt_Clamp_T2.5.SLDPRT | 306.0KB | |
| Belt_Clamp_T2.5.STL | 662.3KB | |
| Y-Carriage_4.SLDPRT | 3.1MB | |
| Y-Carriage_4_fixed.STL | 2.3MB |
