An X Carriage adapter for the Bulldog XL and Prusa i3 (Aurora design).
It is specially designed so that the E3D fan shroud can still fit in the upright position.
NOTE: I mirrored the Bulldog XL by following a YouTube tutorial.
The servo I'm using is the TGY-1440A. (sub-micro servo)
http://hobbyking.com/hobbyking/store/__7475__Turnigy_1440A_Servo_4_4g_0_8kg_10sec_V2_.html
If you don't want to use a servo for the Z probe I have also attached an alternative which utilizes a rubber band snap mechanism. The idea was given to me by a mate.
http://www.thingiverse.com/Aistaca/about
The switch is a DM3 micro switch from Jaycar.
http://www.jaycar.com.au/productView.asp?ID=SM1036
Tolerances have already been accounted for so that the Bulldog XL can sit nicely in the mounting grove.
Most of the screws used are M3 x 15mm.
Optional active cooling.
No supports needed!!
This actually increased my printer speed by 1,200%.
NOTE: the stepper cooling fan that can be seen in some of the images can be found here:
http://www.thingiverse.com/thing:35436
| Bulldog_XL_Adapter_2ver4b.STL | 185.3KB | |
| Fan_Duct_2ver2.STL | 1.2MB | |
| Z_Probe_Servoless_Arm_1ver1.STL | 92.5KB | |
| Z_Probe_Servoless_Mount_1ver2.STL | 83.0KB | |
| Z_Probe_Servoless_Mount_Lock_1ver3.STL | 27.4KB | |
| Z_Probe_Servo_Arm_1ver2.STL | 55.1KB | |
| Z_Probe_Servo_Arm_1ver2_Height_Assistant.STL | 55.6KB | |
| Z_Probe_Servo_Mount_1ver3.STL | 72.6KB | |
| Z_Probe_Servo_Mount_1ver3_Locking.STL | 73.6KB |
