ProxKey Fob Cover 3D Printer Model
The file 'ProxKey Fob Cover 3D Printer Model' is (stl) file type, size is 537.8KB.
The file 'ProxKey Fob Cover 3D Printer Model' is (stl) file type, size is 537.8KB.
A protective cover for a HID Corporation 1346 ProxKey III Key Fob, commonly used to control access to buildings. My fob cracked and the rubber front deteriorated and wore off. This cover keeps the electronics secure from the elements and permits all the good radio waves to pass through.
The original Tighter Half version is tight to the fob and has no additional clearance for the rubber front part. The Top and Bottom version has slightly more clearance.
Sand if necessary until the halves fit over the fob. Scale up and reprint if it's too much sanding. Apply superglue and stick it in a vise until cured. Done.
| ProxKey_Fob_Cover-Bottom.stl | 447.6KB | |
| ProxKey_Fob_Cover-Tighter_Half.stl | 446.7KB | |
| ProxKey_Fob_Cover-Top.stl | 635.1KB |
