Protection Rings // Replacement Buttons With And W/o Letter For Anbernic RG35xxSP 3D Printer Model
The file 'Protection Rings // Replacement Buttons With And W/o Letter For Anbernic RG35xxSP 3D Printer Model' is (stl) file type, size is 132.6KB.
The file 'Protection Rings // Replacement Buttons With And W/o Letter For Anbernic RG35xxSP 3D Printer Model' is (stl) file type, size is 132.6KB.
DISCLAIMER: Modding your electronic devices can be dangerous, and you may end up damaging them. Use at your own risk.
The author of this publication is not responsible for any damage caused as a result of using these models.
Protection Ring added!
If you want to keep your stock buttons, you can print the Ring. Pretty easy, print it, out it on the top of button/dpad, and the membrane itself will hold the ring in place.
Tested!
Try it b4 adding the tape mod, if possible. After that, I recommend only 1 layer of tape, bc the ring make the zone pretty tight.
Enjoy!
V2 Added:
Added a cutout on the button to use with original membrane.
Added bigger & thicker letters , oriented like the original ones
One of the problems of this fantastic console, is the breaking of the membrane under the buttons.
The original buttons are pointy at the bottom, so it ends breaking the membranes
D PAD IS STILL A WORK IN PROGRESS.
Notes:
Print Settings
Supports:
Yes
Resolution:
0,1
Infill:
100%
Notes:
Supports recommended.
In my printer, used a 0.25 nozzle.
| A_button.stl | 67.3KB | |
| Button_without_letter.stl | 63.3KB | |
| B_button.stl | 71.6KB | |
| d-pad.stl | 158.6KB | |
| Slimmer_ring.stl | 9.8KB | |
| X_button.stl | 57.6KB | |
| Y_button.stl | 57.0KB |
