The file 'Project: Laserscythe – Another Open Source Laser Engraver Using Recycled Doohickeys 3D Printer Model' is (stl,STL) file type, size is 1.1MB.
This project is basically a laser engraver frame designed to work with leftover TAZ 3d printer pieces and whatever stuff I had laying around. It should be pretty easy to adapt to whatever size or bearing setup you would like to use. The electronics setup is a clone of villamany’s 3dPburner project (http://3dpburner.blogspot.com/ - http://www.thingiverse.com/thing:610934 ), the only real differences are the 3d printed frame and parts. I wanted to go a different direction with most of the pieces, and I wanted to ensure they were all truly available as open source, so I ended up making my own parts.
This is the first laser I have made or designed, so there may be some tuning required. It seems to work ok so far though!
IMPORTANT NOTE:
Class IV lasers are dangerous if operated incorrectly. NEVER use a laser without proper safety equipment, training, and interlocks. By downloading these files you agree to use them only in a safe, enclosed environment with all safety precautions taken. You further agree that you are qualified to build and operate a laser and will attempt no amateur Lasik surgery.
| Corner_frame_post_1_0_a.stl | 381.3KB | |
| LaserScythe_frame_left_1_0_a.stl | 170.5KB | |
| LaserScythe_frame_left_1_0_a_repaired.stl | 648.0KB | |
| LaserScythe_frame_right_1_0_a.stl | 172.7KB | |
| Laser_blast_shield_1_0_a.stl | 83.5KB | |
| laser_box_1_0_a.stl | 76.8KB | |
| laser_carriage_2_1_a.stl | 249.8KB | |
| Laser_fanduct_1_0_a.stl | 499.1KB | |
| laser_lid_1_0_a.stl | 65.1KB | |
| laser_mount_base_1_0_a.stl | 43.0KB | |
| laser_mount__1_0_a.stl | 97.5KB | |
| Lower_Rail_Fit_test_piece.stl | 3.2KB | |
| X_and_Y_motor_1_0_a.stl | 80.9KB | |
| X_idler_1_0_a.stl | 356.7KB | |
| x_idler_mount.stl | 129.4KB | |
| Y_belt_mount__1_0_a.stl | 296.2KB | |
| y_Idler_mount_1_0_a.STL | 127.6KB | |
| y_idler_mount_post_1_0_a.stl | 197.2KB | |
| Y_idler__1_0_a.stl | 321.0KB | |
| Y_limit_switch_Mount_1_0_a.stl | 64.3KB |
