2-in-1 fan duct for the printrite diy printer. This is the 3rd version wich i think is quite good and worth uploading here. Basically it directs some of the air flow from the fan in to the tip of the nozzle to cool the plastic coming out of it while still cooling the extruder. In my oppinion it helps a lot with overhangs.
I have set my fan to run 100% on all the time even when heating the extruder and had great results!
NOTE: This thing (may) lower the efficiency of cooling the extruder and cause little clogging but i let you to deside on that. (I am not very experienced in printing (yet) =)
| in-1_fan_duct.stl | 395.3KB |
