Printed Truck V2: Cab 3D Printer Model
The file 'Printed Truck V2: Cab 3D Printer Model' is (STL) file type, size is 199.4KB.
The file 'Printed Truck V2: Cab 3D Printer Model' is (STL) file type, size is 199.4KB.
After a bunch of iterations the cab is done! Once this is hooked up it's perfectly driveable :)
Hardware needed:
4x M3x25 for mounting baseplate to frame
4x M3x16-30 for mounting baseplate to cab
4x M3x10-16 for mounting battery holder to baseplate
2x M3 or equivalent for mounting the on/off switch to baseplate
A couple of cable-ties for securing components to baseplate
Some rubber bands to secure battery against battery holder
Optional:
2x5mm LED for headlights
Suitable resistor or driver for the above
You can check out the assembly and drive video for this over at my youtube:
http://www.youtube.com/c/MrCrankyfaceProjects
You can find the other V2-compatible parts here:
Frame: http://www.thingiverse.com/thing:1503418
Rear axle: http://www.thingiverse.com/thing:1470452
Front axle: http://www.thingiverse.com/thing:1460196
Springs: http://www.thingiverse.com/thing:1503424
Gearbox: http://www.thingiverse.com/thing:1392761
Driveshaft: http://www.thingiverse.com/thing:1392796
Rims: http://www.thingiverse.com/thing:1412131
Tyres: http://www.thingiverse.com/thing:1408635
Check me out at:
Youtube: http://www.youtube.com/c/MrCrankyfaceProjects
Instagram: https://www.instagram.com/mr.crankyface/
3d hubs: https://www.3dhubs.com/malm%C3%B6/hubs/mrcrankyface
Patreon: http://patreon.com/Mrcrankyface
| Base_plate2.STL | 285.9KB | |
| Battery_holder.STL | 33.9KB | |
| Cab.STL | 391.1KB |
