Printable ITD Kill Zone 3D Printer Model
The file 'Printable ITD Kill Zone 3D Printer Model' is (stl) file type, size is 1.7MB.
The file 'Printable ITD Kill Zone 3D Printer Model' is (stl) file type, size is 1.7MB.
A printable full-sized Into the Dark sized Kill Zone with an inset grid, magnetic attachments, and numbered panels for easy assembly
Something I threw together while setting up a virtual environment for testing out terrain builds. I haven't done a test print, but likely will later as I work on a themed ITD set. Until then, I figured people could get some use out of just the board
These prints do require support for the insets and numbers, but it's a very small amount compared to the total area
Assembly requires 136 5mm x 1mm round magnets which are all glued into place
The largest panels are 218mm x 218mm so they should just barely fit on a standard Ender 3 build plate
| ITD_Kill_Zone.stl | 40.1KB | |
| Panel_1.stl | 463.4KB | |
| Panel_10.stl | 751.8KB | |
| Panel_11.stl | 695.2KB | |
| Panel_12.stl | 497.0KB | |
| Panel_2.stl | 726.3KB | |
| Panel_3.stl | 765.1KB | |
| Panel_4.stl | 464.7KB | |
| Panel_5.stl | 743.2KB | |
| Panel_6.stl | 1010.0KB | |
| Panel_7.stl | 927.4KB | |
| Panel_8.stl | 796.4KB | |
| Panel_9.stl | 545.8KB |
