This is a printed 4 cylinder 12V motor.
See: http://youtu.be/xJX4PsNLRdk
Based on the principle of a solenoid motor.
I'm busy with cleaning up all the files and fixing a manual. (see: help.odp)
For this moment it is in a prototype phase.
Suggestions and questions are very welcome.
| 1st_crank.stl | 40.2KB | |
| 2nd_3rd_crank.stl | 37.7KB | |
| 4th_crank.stl | 37.8KB | |
| 5th_crank.stl | 36.9KB | |
| axis.stl | 12.3KB | |
| Bearing.scad | 5.3KB | |
| bearing_bracket.scad | 2.3KB | |
| bearing_bracket.stl | 87.2KB | |
| bearing_bracket_top.stl | 38.1KB | |
| bobbin.scad | 1.4KB | |
| bobbin.stl | 37.5KB | |
| bobbin_flange.stl | 48.9KB | |
| cage.stl | 170.8KB | |
| connection_rod.scad | 873.0B | |
| connection_rod.stl | 29.5KB | |
| crankshaft.scad | 6.4KB | |
| duplo_bracket.scad | 2.4KB | |
| duplo_sensor_bracket.stl | 27.2KB | |
| duplo_sensor_bracket_top.stl | 4.6KB | |
| Encoder_disk.scad | 246.0B | |
| Encoder_disk.stl | 61.4KB | |
| help.odp | 284.2KB | |
| inner_house.stl | 105.4KB | |
| outer_house.stl | 107.7KB | |
| outer_house_lid.stl | 105.4KB | |
| plunjer.scad | 990.0B | |
| plunjer.stl | 22.2KB | |
| plunjer_connector.stl | 28.9KB | |
| sensor_bracket.scad | 572.0B |
