(Update) 8/22/20: A long overdue upgrade, I made the hinge thicker. I had left it thin before because I was unsure of other peoples printer tolerances, but I understand the need. Tests were done at 0.2 layer height
Also I don't know why but my original hex case is uploaded twice, I don't want to mess with it soo.. they're both the same, you shouldn't need it anymore anyway unless you have issues with the new hinge sticking

Side note, I know adding the D&D logo or other designs on top has been requested, but I've avoided that for 2 reasons, 1, If I added a raised logo, it'd need support all over suddenly to be able to print it, and it'd print with lots of artifacts because of the supports would be right on the face of it, and 2 if I tried a recessed design, I'd need to up the thickness of the shell and this was meant to be as thin as possible, I just wanted something easy and simple to print. Though I may attempt designs in the future.

Full sized hex dice case with hinge and clasp, no supports needed, just print in place.

FOR MINI DICE, SEE MY MINI DICE CASE! https://www.thingiverse.com/thing:4580029
.
.
.
.
NOT FOR ELDERWOOD DICE!

(For those unfamiliar elderwood put a claim on multiple peoples hexagon shaped cases. You can't copyright a shape and these cases have been around for decades!!)