Pretty Good Bed Leveling & Z-Stop Kit For Makerfarm Pegasus 3D Printer Model
The file 'Pretty Good Bed Leveling & Z-Stop Kit For Makerfarm Pegasus 3D Printer Model' is (stl,skp,FCStd) file type, size is 464.3KB.
The file 'Pretty Good Bed Leveling & Z-Stop Kit For Makerfarm Pegasus 3D Printer Model' is (stl,skp,FCStd) file type, size is 464.3KB.
This is a kit to improve the Makerfarm Pegasus printer's bed leveling. It requires only an M3 bolt driver. It includes a set of nut/spring traps for the heat bed mount, and a Z-axis end stop which is much more accessible. I don't have a wooden heat bed mount, but I included a set of traps for one, assuming the mounting holes are offset in the same dimensions.
The Z-stop arm uses the HammerNut from CaptainObvious (http://www.thingiverse.com/thing:245103), which makes this retro-fittable. No dissassembly is required to change out the end stop.
From the trap-alum or trap-wood STL file, you'll get:
1) Rectangle-ish nut & spring trap for the bottom of the bed (QTY 4)
2) Round spring cap for the top of the spring (QTY 4)
From the zstop-arm STL file, you'll get:
3) Long t-nut "bar" for the Z-axis adjustment screw, with two holes (QTY 1)
4) Angled arm for the end stop switch, with the HammerNut on one end, and a mounting spot for the switch on the other (QTY 1)
See below for assembly tips.
License is inherited from CaptainObvious' HammerNut.
Edit (200721): Added a stronger version 2 trap for the aluminum plate, and the FreeCad design.
| trap-alum.stl | 768.0KB | |
| trap-wood.stl | 775.4KB | |
| trap.skp | 219.1KB | |
| trap_alum_V2.FCStd | 40.7KB | |
| trap_alum_v2.stl | 20.0KB | |
| zstop-arm.skp | 168.9KB | |
| zstop-arm.stl | 340.0KB |
