Predator Armor (Not Screen Accurate) This is a bunch of armor I created for a predator costume I was working on. It is created to fit the LED look I was going for while still looking similar to the original movie. I included both the right and left shoulders, thigh, lower leg, back (both full and cut pieces), Chest (both full and separated), cod, and bicep files that I created. You might have to do some tweaking to get them the way you want them. I don't mind heating and reshaping a little after I print so I generally don't go back and tweak a file unless it had a major issue. I have printed all of these files without a problem. I used elastic to connect and position the pieces after printing them. I have on occasion printed small loops to connect on the back side to run straps through to make pieces fit better. Have fun and enjoy.
I found the gauntlets at https://www.thingiverse.com/thing:2362148
and https://www.thingiverse.com/thing:2362110
I found the shoulder gun at https://www.thingiverse.com/thing:2478709
I found the mask I used at https://www.thingiverse.com/thing:2849460
All of the Bones I used for the necklace I resized and drilled a hole through to string together.
I found the skull I used at https://www.thingiverse.com/thing:389119
The vertebra I used is from https://www.thingiverse.com/thing:472178
The Clavicle bone I used is from https://www.thingiverse.com/thing:368312
| back.stl | 3.5MB | |
| back_1.stl | 3.3MB | |
| back_2.stl | 371.2KB | |
| back_3.stl | 173.9KB | |
| back_4.stl | 68.6KB | |
| back_5.stl | 64.2KB | |
| back_6.stl | 49.3KB | |
| bicep.stl | 196.9KB | |
| calf_bottom.stl | 3.0MB | |
| calf_top.stl | 26.2MB | |
| chest.stl | 1.7MB | |
| chest_1.stl | 101.4KB | |
| chest_2.stl | 123.6KB | |
| chest_3.stl | 107.5KB | |
| chest_4.stl | 101.4KB | |
| cod.stl | 98.0KB | |
| dread_end.stl | 78.2KB | |
| knee.stl | 3.4MB | |
| left_shoulder.stl | 1.8MB | |
| right_shoulder.stl | 300.7KB | |
| thigh.stl | 929.3KB |
