Power Bank Hexagon Case 3D Printer Model
The file 'Power Bank Hexagon Case 3D Printer Model' is (stl) file type, size is 164.4KB.
The file 'Power Bank Hexagon Case 3D Printer Model' is (stl) file type, size is 164.4KB.
In the files are couple version of model so you can custom your power bank.
The middle part is in two version one ( middle for circuit) is prepared for power bank circuit
with photo is included, and version (middle clear) without holes for USB ports so you can make it with other one.
Also you have to make a hole to put there an button (showed on picture)
Mounting 3d printed button is pretty tricky becouse you have to glue button on (in my case)
pice of wire so that it can freely ''click''
I modified the PCB by unsodering the button and replacing the new one by wires in a gap.
LED hole I drilled after the print and I unsolder LED from board and reconected it by wire.
This case fills nine 18650 batteries but it fits very tight, to connect batteries use a
silver strip or very thin wires.
After closing up everything glue frontplate or mount it in some different way ( magnets or screws, I have been very lazy so I just glued it up ;) )
| Backplate_clear.stl | 133.4KB | |
| Backplate_logo.stl | 238.2KB | |
| Button.stl | 36.0KB | |
| Frontplate.stl | 125.1KB | |
| Middle_clear.stl | 70.0KB | |
| Middle_for_circout.stl | 226.9KB |
