POTP Volcanicus Feet 3D Printer Model
The file 'POTP Volcanicus Feet 3D Printer Model' is (stl) file type, size is 869.0KB.
The file 'POTP Volcanicus Feet 3D Printer Model' is (stl) file type, size is 869.0KB.
New feet that look more fitting for POTP Volcanicus then the ones that the figure comes with. Volcanicus pictured with other awesome mods installed from Thingiverse.
The Feet are based on files from a Warhammer Titan Wardog, and the ball socket/lock comes from a Locking Ball/Socket articulated arm thing on Thingiverse.
You'll need to print both the left and right foot, 2x Sockets, 2x Locks, and 2x Ball Joints. I've proved an stl with all the connectors, and also individually. You may need to use a raft for the connectors to keep them on the build plate.
The feet you can print with 15-20% infill and layer height of 0.2, but lower would be recommend for better detail. As for the connectors I would recommend they be printed with 100% infill for strength.
To assemble, place the ball into the socket, then place the lock and twist. You may need to use some locking pliers and a wrench to get it to twist. One click is enough, as the lock doesn't increase pressure on the ball. If you have a hard time, you may need to sand down some parts as the fit is tight. Place the socket into the foot, it should fit snug. If so desired you can superglue the socket into the foot as well.
| Volcanicus_Feet_V1_-_Ball_Connector.stl | 157.8KB | |
| Volcanicus_Feet_V1_-_Connectors.stl | 655.6KB | |
| Volcanicus_Feet_V1_-_Left_Foot.stl | 701.5KB | |
| Volcanicus_Feet_V1_-_Lock.stl | 54.1KB | |
| Volcanicus_Feet_V1_-_Right_Foot.stl | 701.5KB | |
| Volcanicus_Feet_V1_-_Socket.stl | 132.2KB |
