Note: Due to bugs, the general instability of Thingiverse, a data leak and numerous bots, spam comments etc. I will no longer upload my files here. The following link will take you to the upload of the model on my Printablesaccount: https://www.printables.com/model/293191-pot-with-lid

Thank you for your understanding!

Three minimalistic pots in three different sizes with lids!
The pots can of course also be used without the lids, I have the edges on which the lid rests purposely kept simple.
The model has no critical overhangs, so everyone should get a wonderful print result.
Please follow the printing instructions below to get the best result.

Print instruction:
I recommend printing the lids with a layer height of 0.2mm. 3 perimeters and 10% infill are sufficient. The slightly angled top of the lid should be printed with a layer height of 0.1 to 0.12mm for a much nicer result. This can be set in the Prusaslicer via "Variable layer height" as shown in the picture. The color change is best set to the height where the diameter of the sphere is somewhat equal. But of course this is up to you.

I recommend printing the pots with a layer height of 0.2 to 0.25mm. 3 perimeters and 10% infill are sufficient. From a height of 20mm, the infill can be set to 0%, the pot is still sturdy.