Portable Spinning Keychain Hanger (Redesigned) 3D Printer Model
The file 'Portable Spinning Keychain Hanger (Redesigned) 3D Printer Model' is (stl) file type, size is 13.1MB.
The file 'Portable Spinning Keychain Hanger (Redesigned) 3D Printer Model' is (stl) file type, size is 13.1MB.
A redesign of my original Portable Spinning Keychain Hanger, located here:
https://cults3d.com/en/3d-model/jewelry/keychain-display-rotating-hanger
which originally had the entire pole or center cylinders spin together with the hanger arms.
This version allows each level to spin freely and also has a sturdier base, which was redesigned to allow the user to fill it up with sand (once filled, superglue the cap to the base as it was designed to be permanently sealed). This keeps the hanger from toppling over.
The portability aspect was kept, however this time instead of each center cylinder unscrewing into the lower one, each cylinder is instead unscrewed one after the other.
This is also a modular design, meaning if you want to add another level, you can print another one of the Second Cylinder P2 and another Bearing with Bearing Cover + Arms, although I do not recommend doing this without filling up the base with sand before.
The Arms Ends pieces are the parts that go in the holes on each of the Arms in order to keep the keychains from falling out.
The Top Cap part is the piece used as the last/top section of the hanger in order to "finish" it.
If you are using brims, I attached a picture of where you should make some cuts in order to free the rotating arms. Make sure to get rid of all the brims around this area as it will affect the rotation.
| Arms_Ends.stl | 542.9KB | |
| Base_Cover.stl | 56.3KB | |
| Base_Lower.stl | 3.9MB | |
| Bearing_32mm_Diameter.stl | 1.8MB | |
| Bearing_Cover_+_Arms.stl | 6.6MB | |
| First_Cylinder_P1.stl | 7.6MB | |
| Second_Cylinder_P2.stl | 7.8MB | |
| Top_Cap.stl | 4.1MB |
