Alternate latches for the Pop-up Gift Card Box with larger filament holes.
The original latch files have 2.2mm holes and are made to be a tight fit with 1.75mm filament.
These latches have 2.6mm holes, which will more easily accept 1.75mm filament. You may need to use glue or heat to seal up the holes and keep the filament from falling out.
The holes in the case are still the tighter 2.2mm diameter to keep filament from slipping in that crucial spot.
| All_Files.zip | 666.8KB | |
| Alternate_Latch_Holder_No_Supports_Larger_Filament_Hole.stl | 258.3KB | |
| Band_Flower.stl | 785.9KB | |
| Band_Snow.stl | 198.9KB | |
| Band_Thin.stl | 43.1KB | |
| Band_Wide.stl | 65.7KB | |
| Box_Plain.stl | 250.3KB | |
| Box_Plain_Bottom.stl | 169.2KB | |
| Box_Plain_Top.stl | 143.5KB | |
| Box_with_Diamond_Texture.stl | 305.6KB | |
| Latch_Bottom_Larger_Filament_Hole.stl | 169.2KB | |
| Latch_Holder_Larger_Filament_Hole.stl | 279.0KB | |
| Latch_Middle_Larger_Filament_Hole.stl | 221.4KB | |
| Latch_Top_Larger_Filament_Hole.stl | 193.6KB |
