Late submission for the eclipse tomorrow, but here it is. Use's 3mmx2mm magnets in the corners to hold the face plate on. If you don't have magnets handy, small clamps or clips should work ok too.
This is designed for a Chinese knockoff go pro, so I don't know how well standard mounts will fit. V3 has more coverage to prevent reflections inside, V2 is more open to fit more cameras.
I'm using mylar as my filter. Place a small piece of your filter on the front, snap the faceplate on, and trim to fit.
| faceplateV2.stl | 346.3KB | |
| GoProFilterHolderV2.stl | 348.3KB | |
| GoProFilterHolderV3.stl | 458.2KB |
