Gun stock for the Oculus Quest using an European size PVC pipe used for electrical conduit (20mm Outer Diameter).
ATTENTION: Quest 2 and 3 controllers not tested - check messages from the community
(Please do not ask privately for a remix, but feel free to adapt the design to your needs and share it to the community)
Both Oculus Touch VR controllers can be detached, 5 Neodymium magnets will snap them back in position. If you prefer your dominant hand to not detach from the gun body, just print the controller mount and pipe connector separately and glue them.
Gun shoulder stock can be raised and lowered for better comfort.
Use rivets or screws to fix the parts to the pvc pipe.
Use super glue to fix the magnets to the prints.
Assembly time: 3-5 minutes.
https://steamcommunity.com/sharedfiles/filedetails/?id=2173429503
Shopping list:
n.1 // European PVC pipe used for electrical conduit (20mm Outer Diameter).
n.16 // Cheap Neodymium magnets https://www.amazon.de/gp/product/B07SJZNZ3N/
Shape: round.
Size: Diameter: 10 mm, thickness: 2 mm.
n.1 // M5 Nut + Bolt (25mm)
Few rivets or screws
Super glue
Total cost: 10 Eur
/// Please leave a comment for future improvements ///
Added f3d file for easier remixing.
| band_ring.stl | 56.6KB | |
| Buttstock.stl | 118.3KB | |
| Buttstock_pipe_connect.stl | 211.2KB | |
| controller_LH_mount_5mags.stl | 1.5MB | |
| controller_RH_mount_5mags.stl | 1.5MB | |
| gun_terminal.stl | 370.6KB | |
| pipe_connect_5mags.stl | 81.8KB | |
| Poor_man_gunstock.f3d | 17.5MB |
