Replacement hinge pins for center console cover for Pontiac Vibe or Toyota Matrix or Corola about 2003 to 2007 models. should be printed in PETG or ABS, PLA will deform from the heat.
TPU is a good choice if printed at 100% infil. TPU is very tough
Added two more designs, one with fillets and one with the ridge the original has.
Added a set for 2005 to 2007 Matrix models because they are larger than the early modes.
I suggest printing with TPU and for supports, In Cura change the interface from Zigzag to Lines, Its much easier to remove the supports using lines. that makes the orientation of the print less important The Print flat version changes the orientation of the slot for the pin so it can be printed flat. the others are designed to print vertical
I added the FreeCad file I made to make the model
| CE3E3V2_matrix_2005.3mf | 250.8KB | |
| matrix__2005_to_2007.FCStd | 2.3MB | |
| _Vibe_Mirrored_part.stl | 109.0KB | |
| _Vibe_Mirrored_partFilet01.stl | 198.5KB | |
| _Vibe_Mirrored_parttest01-Fusion002.stl | 108.2KB | |
| _Vibe_Mirrored_parttest01.FCStd | 103.3KB | |
| _Vibe_Mirrored_parttest0PrintFlat.stl | 250.1KB | |
| _Vibe_Toyota_part.stl | 64.3KB |
